Step by Step Instructions
1. Boot up both The VTH and VTO. The initial page will ask you to change the Region and Language. Click on the Region
2. Locate and select your region. Then click on OK
3. English will be selected by default so click on OK.
4. Select Villa then OK
5. Select First-time Config then click on OK
6. The VTH will automatically be set to DHCP and will grab an IP address from the router.:
- Note: If you are assigning a static IP select Static IP and enter a valid IP Address
7. Enter a password and an email for the VTH then click on Next.
8. Enter a Password and an email for the VTO then click on next.:
- Note:VTO will require a 8 character password (Alphabetical and Numerical Combination)
9. Click on the Initialize buttons to finish the initialization process. This will take a few seconds.
10. Click on Next when the initialize buttons grey out.
11. The VTH is now fully setup. The VTO will grab a DHCP address but we still need to edit the settings.
12. Here you can assign it a Static IP address or leave it on the acquired IP. Video Standard will be on PAL by default so select NTSC. Manually enter the time and date. Click on OK when completed
13. Click on One-key Config to finalize the setup.
14. The VTO will reboot and the percentage will stay at 66% until it fully boots back up.
15. IMPORTANT: Let the VTO finalize any last configuration for at least ONE MINUTE before initiating a callIntercom