How to setup P2P on Dahua?

Fred
2020-10-02 16:50

Description

This article will go over initializing P2P on our New GUI devices

Prerequisites

  • Recorder with New GUI
  • Internet Access to the recorder

Step by Step Instructions

1. Under "Management" go to Network>TCP/IP

NewGUIP2PSetup-1.jpg

2. You can either set the device on a static ip or turn DHCP on to automatically grab an IP from the network. Save any changes

NewGUIP2PSetup-2.jpg

3. Locate P2P tab on the lower left and enable P2P

NewGUIP2PSetup-3.jpg

4. After saving it you should see the the status change to "Online", You can now use this device for remote viewing on our software

NewGUIP2PSetup-4.jpg

  • If you run into any issues getting the P2P to show online, reboot the device and try again. If that still doesn't work you may have a firewall on the network that is blocking the connection to the P2P servers
Tags: XVR-I
Average rating: 0 (0 Votes)

You cannot comment on this entry